The Most Common Problems With Dinosaur Models

When we use the simulated large-scale dinosaur model, it is inevitable that some problems will occur, but if it is a temporary problem, it can only be dealt with urgently; of course, if it is some intractable problem, it is necessary to contact the manufacturer for assistance. The following is a detailed introduction to the five points that are most prone to problems with dinosaur models:

1. Sharp objects scratched the skin of the dinosaur, cracks or cracks appeared

Solution: The skin is composed of silicone and fiber cloth. If the skin is cut with a sharp tool during use, it is prone to cracks. At this point you can use needle and thread to sew the cracks (make the stitches as neat as possible), then take the clear glass glue from the repair kit, apply an even layer of glass glue to the sewn cracks, then after drying Simple maintenance.

2. There is no sound when operating (only for electric mechanical dinosaurs)

Solution: When the dinosaur opened its mouth, there was no sound from the speakers. If it is an external speaker, first observe whether the power indicator on the speaker lights up when you open your mouth. The SD card inserted into the speaker is in poor contact or is damaged; if the speaker indicator is not on, the external speaker may be damaged, and you can purchase a speaker of the corresponding model to replace it.

3. After the power is turned on, the dinosaur does not respond

Solution: Check whether the indicator light of the controller is on. If the indicator light is on, shake your arm in front of the sensor probe. If the machine still does not respond, the sensor probe may be damaged. It is possible to tell if a fault has occurred by replacing the sensor probe with a probe from a faultless machine. After confirming the fault, take out the new sensor probe from the repair parts and replace it.

4. There is abnormal sound inside the simulated dinosaur model

Solution: For example, when the tail is swung to one side, the motor part makes a high-pitched abnormal sound in the ear. This condition may be caused by friction after the machine is deformed by an external force. You need to contact us and our technicians will assist you in correcting and restoring the mechanical structure. If the tail keeps making unusual noises, the motor reducer or bearing may be stuck. At this point, the faulty motor reducer or bearing needs to be replaced.

5. The dinosaur model does not act according to the settings (for example, just the mouth does not respond)

Solution: The machine has operations, but only some operations fail. At this time, it is predicted that the fuse corresponding to the action is broken. You need to use a screwdriver. After turning on the black controller, visually check whether the fuse on the circuit board is blown (the fuse is a transparent car case fuse, you can visually check if the wire is broken), if so, replace it with the corresponding color fuse, but if If it still does not work after replacing the fuse, you need to contact us immediately.